The following instructions are for installing or changing the hard drive, which is required to save recordings to the local DVR system. If your DVR already has a hard drive pre-installed, disregard this step.
* Ensure the DVR is unplugged and removed from the main power.
A) Locate the screws on the side and rear of the DVR. Use a screwdriver to remove the screws.
B) Pull up the top half of the DVR case and remove it.
C) Prepare the hard drive (HDD) and four screws used to secure the HDD.
D) If you are changing a hard drive, remove the power and SATA cables from the hard drive. Replace the hard drive and plug in the power and SATA cables to the hard drive while paying attention to the orientation of the HDD.
E) Carefully place the hard drive to match the mounting holes on the bottom and the side of the DVR case.
F) Screw in the hard drive to the bottom of the case. Screw in the remaining screws to the sides and back of the DVR.
G) Power on the DVR and go to the Main menu - HDD menu. Select Format to format the hard drive to get it ready for recording.
Comments
0 comments
Please sign in to leave a comment.